You let the door go. It swings shut, then stops a few inches short. Or it hits the frame and bounces back open.
Now the door isn't locked. Cold or hot air gets in. And if it's an exit door, it may not work the way it should.
Most of the time the problem is one of three things: the closer, the hinges, or the frame. Here is how to tell which one.
Watch the door close
Open the door all the way. Let it go. Watch the last few inches closely. What you see tells you a lot.
- Slows down and stops short. Likely the closer.
- Rubs or scrapes the frame. Likely the hinges.
- Hits the frame and bounces back. Likely hinges or frame.
- Closes but won't latch. Could be any of the three, or the latch itself.
1. The door closer
The closer is the arm at the top of the door. It pulls the door shut. Inside, it uses oil and a spring.
Signs the closer is the problem:
- The door shuts slower than it used to
- It stops before the latch catches
- You see oil on the closer or the floor under it
- The arm is loose or bent
The fix: a closer has small valves that set its speed. Often a simple adjustment gets the door to latch again. If the closer leaks oil, adjusting won't last. It needs to be replaced.
2. The hinges
Doors are heavy. Over time, the weight pulls on the top hinge. Screws loosen. Hinges wear. The door drops a little, and the far corner starts to drag.
Signs the hinges are the problem:
- The door rubs the frame at the top corner on the latch side
- There's a bigger gap at the top on the hinge side
- Hinge screws are loose or stripped
- The door drags on the floor or threshold
The fix: tighten or replace loose screws and worn hinges. For heavy doors that keep sagging, a continuous hinge runs the whole height of the door and holds it up for good.
3. The frame
Sometimes the door is fine, but the frame isn't. A frame can get bent by a hit from a cart or a forced entry. Buildings can also shift a bit over time.
Signs the frame is the problem:
- The frame looks bent, dented, or out of square
- The strike plate (the metal plate the latch goes into) is loose or moved
- New hinges didn't fix the rubbing
The fix: small problems can be fixed by moving or adjusting the strike. A badly bent frame may need to be straightened or replaced.
Don't forget the small stuff
Some doors stop short because something is in the way. A new weatherstrip that's too thick. A high threshold. A door sweep that drags. These are easy to miss and easy to fix.
Why it matters
A door that doesn't close is a door that isn't locked. On a storefront or back door, that's a real risk. And it costs you money on heating and cooling.
The good news: most of these fixes take one visit. You get the price before we start.
Not sure which one it is?
Take a short video of the door closing and send it to us. We'll tell you what we think is wrong.
Send us a message or call (682) 324-6688. We are open Monday to Friday, 7:30 AM to 6 PM, and we call back the same business day.
Quick answers
Why does my door stop just before it closes?
Most often the door closer is set too slow, is worn out, or is leaking oil. It can also be something in the way, like a thick weatherstrip or a high threshold.
Can a door closer be adjusted, or does it need to be replaced?
Many closers can be adjusted to fix the closing speed. If the closer is leaking oil, it needs to be replaced, because an adjustment won't last.
How do I know if my door is sagging?
Look for a door that rubs the frame at the top corner on the latch side, or a bigger gap at the top on the hinge side. Loose hinge screws are another sign.
